Payment & Shipping Terms:
|Name:||Gear Shift Knob||Color:||Silver|
|Term Of Trade:||E X W ( Guangzhou)||Place Of Origin:||China|
Aluminum Gear Shift Knob with 3 Sizes Adapter for Honda Mazda Nissan Toyota and More (Silver)
|Name:Gear Shift Knob||Material:Aluminum|
|Color:Silver||Term of Trade:E X W ( Guangzhou)|
Place of Origin:China
Manual transmission gear shift :
When the manual transmission lever is operated, the grip of the lever handle is shown in figure 2-25, with the handle of the handle, and the five fingers naturally hold the handle.When manipulating the shift lever, the two eyes should focus on the front: the left hand grips the steering wheel.Loose in his right foot up the accelerator pedal at the same time, his left foot on the clutch pedal, the power of his right hand wrist, elbow after before the shift lever to push or pull, in order to realize the pick out or hangs in a selected block.
Automatic transmission gear shift lever:
(1) before starting the engine, the control handle must be in "P, T, or" N ".
(2) when the engine runs, it should step on the brake pedal before putting the handle to any stop.
(3) to stop the car, engine idle running) will control handle on a driving gear, and need to open the engine hatch during work, ban pull the throttle actuator, in case the car suddenly started accident.Therefore, before you need to check the running engine, you must put the control handle in the "P" position and pull the parking brake to the extreme position.
(4) in the running, the control handle should be placed in the "N" stop, and the accelerator pedal should be lifted immediately, and the control handle should be placed in the desired position, and continue to accelerate forward.
(5) when descending the steep slope, the control handle should be placed in low gear, so that the speed control can be controlled in a lower range.
Note the event/shift :
Shift when the eyes look at the front, not bowed down their heads, and the transmission lever, may not be strong push hard pull transmission joystick, before starting to hang not into gear, can hang loose again after a clutch pedal, hang back block, vehicles should be a full stop, remove reverse gear mounted into the locking device, shift lever to neutral, not moving back and forth.
1.Positive Feedback is very important to us.if you are satisfied with our service, please remeber to give a positive feedback.
2.Please contact us before leaving neutral or negative feedback,we will try our best to solve the problems.
3.If you are not satisfied with our best to solve the problems,please contanct us before leaving your feedback and we will resolve the issue immediately.thank you very much.
High quality and Durable